When the summer hits your place,then we would go for the car A/C system repair work in our to do list.Here are the tips to guide you through the diagnostic process with the information to replace the A/C compressor or recharge and clean the a/c system.

 

First you need to eliminate the clutch in your A/C compressor as the culprit.Turn on your  A/C and fans to max settings. Is the clutch engaging  properly or not ? If not,use a voltmeter to see if the compressor is receiving voltage.

A/C Gas Refilling

If there’s voltage, the clutch may be worn out. Replacement of the clutch and/or compressor would be necessary. If there’s no voltage, there may not be sufficient refrigerant in the system to engage the low pressure cut-off switch that cycles the compressor. If it seems likely that there isn’t enough refrigerant in the system, the typical culprit is a leak. Use a UV A/C leak detector kit to check for leaks, including in the condenser and evaporator.

 

Next, use a manifold gauge to check the high and low side pressures in the system. Are they set within the recommended ranges provided in your owner’s/repair manual? Also, check the following for a tight and secure fit:

  • Front seal of compressor
  • All system fittings
  • Hose manifolds on compressor
  • All system hose crimps
  • Schrader valves
  • O-rings found on compressor pressure switches

 

If you need to replace your A/C compressor, you’ll also need to replace your accumulator and/or dryer and expansion device. You’ll also want to conduct a full flush of the system for optimal performance.  Some vehicles require a replacement of the condenser to eliminate all debris from the A/C system.

A/C RECHARGING

The EPA provides detailed information about the process and regulations. You can read them in full or use the summary we’ve provided below.

When recharging, there are two main options:

  • Top off with refrigerant
  • Empty/evacuate the system and recharge/refill the system

A/C Charging

HOW TO FIND A REFRIGERANT LEAKAGE

If only a small amount of refrigerant appears to be left, you’ll need to add up to a few volumes. (Note that at least 2 to 3.5 litres of refrigerant is needed to test cooling capabilities.)

It’s possible to have pinpoint-sized leaks that are very difficult to find, even with the best equipment. These tiny leaks cause slow leakage but the A/C system may seem to lose its cooling capabilities virtually all at once. If that’s the case, it’s likely that your vehicle has a system that shuts off once refrigerant drops below a certain level.

 

STREAMLINED PROCESS

If you decide to just add refrigerant, A/C Pro is a solution to consider. It contains a sealant that helps stop leaks on hoses, gaskets and o-rings.

Here are the basic steps to use it correctly:

  • Locate the low-pressure connection point
  • Use the A/C Pro gauge to measure the system’s pressure
  • If low, refill by pulling the trigger on the product’s nozzle and monitor pressure via the pressure gauge device, making sure that you don’t overfill

We at Doers would take care of the A/C repairs and maintenance at the city near you just click on www.doers.co.in and book the service today.


Leave a Reply

Your email address will not be published. Required fields are marked *